Handheld-entertainment Document Reader 4800dr Bedienungsanleitung PDF herunterladen (Seite 35)

4800dr Barcode Guide 3 - 13

To program the previous example using specific lengths, you would have to count any programmed prefixes, suffixes, or

formatted characters as part of the length. If you use the example on page 3-12, but assume a <CR> suffix and specific code

lengths, you would use the following command line:

SEQBLK62001241FF6A001342FF69001243FF

The breakdown of the command line is shown below:

SEQBLK sequence editor start command

62 code identifier for Code 39

0012 A - Code 39 sample length (11) plus CR suffix (1) = 12

41 start character match for Code 39, 41h = “A”

FF termination string for first code

6A code identifier for Code 128

0013 B - Code 128 sample length (12) plus CR suffix (1) = 13

42 start character match for Code 128, 42h = “B”

FF termination string for second code

69 code identifier for Code 93

0012 C - Code 93 sample length (11) plus CR suffix (1) = 12

43 start character match for Code 93, 43h = “C”

FF termination string for third code

Output Sequence Editor

Require Output Sequence

When an output sequence is

Required

, all output data must conform to an edited sequence or the document reader will not

transmit the output data to the host device. When it’s

On/Not Required

, the document reader will attempt to get the output data

to conform to an edited sequence, but if it cannot, the document reader transmits all output data to the host device as is.

When the output sequence is

Off

, the barcode data is output to the host as the document reader decodes it.

Note: This selection is unavailable when the Multiple Symbols Selection is turned on.

Enter Sequence

Default Sequence

Required

On/Not Required

*Off

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 139 140

Keine Kommentare

Handheld-entertainment Document Reader 4800dr Bedienungsanleitung Seite 35