
4800dr Barcode Guide 6 - 3
When Check Character is set to
Validate, but Don’t Transmit
, the unit will only read Codabar barcodes printed
with
a check
character, but will not transmit the check character with the scanned data.
Codabar Concatenation
Codabar supports symbol concatenation. When you enable concatenation, the document reader looks for a Codabar symbol
having a “D” start character, adjacent to a symbol having a “D” stop character. In this case the two messages are concatenated
into one with the “D” characters omitted. Default = On.
Select Require to prevent the document reader from decoding a single “D” Codabar symbol without its companion. This selection
has no effect on Codabar symbols without Stop/Start D characters.
Codabar Message Length
Scan the barcodes below to change the message length. Refer to Message Length Description (page 6-1) for additional
information. Minimum and Maximum lengths = 2-60. Minimum Default = 4, Maximum Default = 60.
* No Check Character
Validate Modulo 16
and Transmit
Validate Modulo 16, but
Don’t Transmit
A12D D34A
Codabar
Character
Stop Start StopStart
Minimum Message Length
Maximum Message Length
Kommentare zu diesen Handbüchern